Adaptec 2120S - SCSI RAID Controller Guide de l'utilisateur télécharger pdf (Page 95)

5-47

container Commands

{container}...

Specifies the ID number (0 to 63) of the array or arrays to add

to the previously specified multilevel volume set. The previous

file system information applies to these additional arrays as

well.

Examples

Before extending a multilevel volume set, use the container

list

command to obtain information about any existing arrays.

As the following example shows, there is an array 0 (a multilevel

volume set) on this controller. In addition, the example shows array

1 and array 2 (both volume sets created with the container

create volume

command).

AAC0>container list

Executing: container list

Num Total Oth Stripe Scsi Partition

Dr Label Type Size Ctr Size Usage C:ID:L Offset:Size

-- ----- ------ ------ --- ------ ------- ------ -------------

F: 0 Volume 10MB NTFS

63 Volume 10MB 0:02:0 64.0KB: 10.0MB

1 Volume 15MB None 0:03:0 64.0KB: 15.0MB

2 Volume 15MB None 0:04:0 64.0KB: 15.0MB

The following example extends a multilevel volume set (array 0) by

adding arrays 1 and 2 (which are both volume sets):

AAC0>container extend mvolume 0 1 2

Executing: container extend mvolume 0 1 2

container 0 extended

As the command executes, note that the title bar of the DOS window

displays the status of the command. For example:

Stat:OK!Task:102,Func:FSX Ctr:0,State:RUN 84.3%

See page 3-10 for detailed information on the status information that

the command displays in the title bar as it executes the task.

Use the container list

command after using the container

extend mvolume

command to display information about the

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 353 354

Pas de commentaire

Adaptec 2120S - SCSI RAID Controller Guide de l'utilisateur Page 95