Adaptec 2120S - SCSI RAID Controller Guide de l'utilisateur télécharger pdf (Page 113)

5-65

container Commands

container lock

Caution: Use the container lock command only under

the direction of technical support.

To lock an array into volatile memory space on the currently opened

controller, use the container lock

command. When an array is

locked into volatile memory space, the container reconfigure

command has no effect. A locked array cannot be moved, deleted,

made read-only, or used to create a multilevel array.

Syntax

container lock {container}

Parameters

{container}

Specifies the ID number (0 to 63) of the array to lock into

volatile memory space.

Examples

Before locking an array, use the container list command

(with the /full switch) to obtain information about any existing

arrays. As the following example shows, there is an array 0 (a

volume set) on this controller. Note that the Lk column is blank:

AAC0>container list /full

Executing: container list /full=TRUE

Num Total Oth Stripe Scsi

Dr Label Type Size Ctr Size Usage C:ID:L Lk

-- ----- ------ ------ --- ------ ------- -------- --

F: 0 Volume 10.0MB NTFS 0:02:0

Note that the example eliminates some items in the container

list display so that you can see an example of the Lk column.

The following example locks array 0 into volatile memory space:

AAC0>container lock 0

Executing: container lock 0

1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 353 354

Pas de commentaire

Adaptec 2120S - SCSI RAID Controller Guide de l'utilisateur Page 113