
5-61
container Commands
FmtNTFS
An array format NTFS file system task is running on
the specified array. The format NTFS file system task
runs as a result of using the container format
command with the
/file_system switch set to
NTFS.
Rebuild
A rebuild task is running on the specified array.
Typically, the rebuild task runs when the controller is
in a rebuild for a redundant array (RAID-5 set, mirror
set, or multilevel array of mirror sets).
Reconfg
An array reconfigure task is running on the specified
array. When the array reconfigure task completes, the
specified array becomes a different array (for example,
from a volume set to a stripe set). The array
reconfigure task runs as a result of using the
container reconfigure command.
Scrub
A scrub task is running on the specified redundant
array. When the scrub task completes, the specified
redundant array has reconstructed data on one
partition based on data found on the other partition
(for mirror sets and multilevel arrays of mirror sets).
Or, the specified redundant array recalculates and
replaces, if necessary, the parity information (for
RAID-5 sets). The scrub task runs as a result of the
container scrub command. The scrub task also
runs as a result of the container create raid5
command with the
/scrub switch specified.
Verify
A verify with no repair of bad blocks task is running
on the specified SCSI disk. When the verify with no
repair of bad blocks task completes, the specified SCSI
disk’s blocks were verified without repairing any
detected defects. The verify with no repair of bad
blocks task runs as a result of using the
disk
verify
command without specifying the /repair
switch.
VfyRepl
A verify with repair of bad blocks task is running on
the specified SCSI disk. When the verify with repair of
bad blocks task completes, the specified SCSI disk’s
blocks are verified with repairs. The verify with repair
of bad blocks task runs as a result of using the
disk
verify
command with the /repair switch.
Table 5-4. Task Types (Continued)
Task Meaning
Commentaires sur ces manuels