Adaptec 2120S - SCSI RAID Controller Guide de l'utilisateur télécharger pdf (Page 78)

5-30

Adaptec SCSI RAID Software Reference Guide

container create stripe

To create a stripe set from freespace, use the container create

stripe

command.

Notes

If you created a stripe set you can run the list devices

command on the NetWare console to verify its creation and then

create the necessary NetWare disk partitions and volumes.

For information on how to create partitions and volumes, see the

appropriate NetWare documentation.

Syntax

container create stripe [/cache{=boolean}]

[/stripe_size{=integer}] [/label{=string}]

{free_space} [{scsi_device}...]

Parameters

{free_space}

Specifies the SCSI device and its associated freespace used to

create the stripe set. See the free_space section on page 3-8

for more information on how to specify the freespace.

{scsi_device}...

Specifies one or more SCSI devices. A SCSI ID consists of a

SCSI bus number (e.g., 0, 1, 2, 3, etc.), SCSI device ID (0

through 15 inclusive), and SCSI device logical unit number (0

through 7 inclusive). See the installation guide for your

controller to determine the number of buses it actually

supports.

See the scsi_device section on page 3-7 for more

information on how to specify the SCSI device. The command

uses the freespace(s) from the SCSI device(s) to create the

stripe set. The size from the device is identical to the one you

specify in the free_space

parameter.

The minimum number of partitions for a stripe set is 2, and the

maximum number is 16.

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 353 354

Pas de commentaire

Adaptec 2120S - SCSI RAID Controller Guide de l'utilisateur Page 78