Adaptec PCI Ethernet and Fast Ethernet Adapters Guide de l'utilisateur télécharger pdf (Page 84)

10-12

Fast Ethernet Network Interface Cards

Network Client Setup

When connecting DOS or VLM clients to a server with Duralink

Failover, insert the following lines into the

net.cfg

file for each client

protocol ipx

ipx retry count 255

For Netware Client32 support for Windows 95 and NT, type 255

under the IPX retry count in the “IPX 32-bit Protocol for the Novell

IntranetWare Clients” in the Network Control Panel.

Reconfiguring Using foconfig.nlm

After initial installation of the Duralink Failover software for

NetWare, you can reconfigure ports and pairs through the

foconfig

program.

Note:

In version 2.0 of Duralink Failover the command for

entering the configuration program was forcnfg.

At the prompt, type load foconfig to load the configuration module.

Follow the procedures for configuring ports and Failover Pairs from

fosetup described earlier in this chapter.

Duralink Failover Config

< F1> Help

Netware Loadable Module

Main Menu

Configure Ports

Set Failover Pairs

Configure Protocols

View Configuration

Use arrow keys to move, <Enter> to Select, <ESC> to Exit.

< F10> Abort Setup

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 121 122

Pas de commentaire

Adaptec PCI Ethernet and Fast Ethernet Adapters Guide de l'utilisateur Page 84