Adaptec PCI Ethernet and Fast Ethernet Adapters Guide de l'utilisateur télécharger pdf (Page 73)

10-1

▼▼▼▼

Installing Duralink Drivers

for NetWare

This chapter describes how to install the Duralink Failover utility on

a server running NetWare 4.1x/3.1x. Instructions in this section

cover both initial installation from the

fosetup.nlm

file contained on

the Duralink Installation Diskette, as well as instructions on

changing the configuration using the

foconfig.nlm

utility (residing

on the server after installation). Use foconfig or fosetup to install or

configure Duralink Failover. Otherwise, fostatus may not show the

proper configuration.

Installation Overview

The following procedures are covered in this chapter

■

Removing Previously Configured Drivers

on page 10-2

■

Initial Installation and Configuration of Duralink Failover

page 10-3

■

Viewing System Status Using fostatus.nlm

on page 10-10

■

Network Client Setup

on page 10-12

■

Reconfiguring Using foconfig.nlm

on page 10-12

Installation, configuration, and optional parameters for the Duralink

Failover utility are updated regularly. The

readme

subdirectory

contains supplemental installation instructions, as well as

information about optional keywords.

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 121 122

Pas de commentaire

Adaptec PCI Ethernet and Fast Ethernet Adapters Guide de l'utilisateur Page 73