Adaptec PCI Ethernet and Fast Ethernet Adapters Guide de l'utilisateur télécharger pdf (Page 74)

10-2

Fast Ethernet Network Interface Cards

Removing Previously Configured Drivers

If you have installed Duralink or Adaptec Ethernet drivers prior to

this installation, complete this section. This is to ensure that no

conflicts exist between previously installed drivers and Duralink

Failover. Do not install Duralink Failover 3.0 over 2.0.

Remove all load and bind commands related to EMPCI,

failover.ncf

fover.ncf

loadbal.ncf

from the

autoexec.ncf

Caution:

Be sure to remove only these commands.

Errors may result in problems with other programs or

system components!

At the server prompt, type load inetcfg and press Enter.

Select Boards and press Enter.

Delete all existing EMPCI boards by selecting each and

pressing DEL.

Press ESC to exit

inetcfg

Fresh NetWare Installation

If you are loading NetWare on a new server, do not add a

LAN/Ethernet adapter when prompted in the NetWare setup

procedures. When prompted to add a LAN adapter, select No and

continue with the NetWare installation. Then proceed to the

following section.

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 121 122

Pas de commentaire

Adaptec PCI Ethernet and Fast Ethernet Adapters Guide de l'utilisateur Page 74