Adaptec PCI Ethernet and Fast Ethernet Adapters Guide de l'utilisateur télécharger pdf (Page 83)

10-11

Installing Duralink Drivers for NetWare

Note:

This requires that the Failover software be loaded or

an error will occur. If you have not rebooted since you

installed the software, reboot and the above screen will

appear automatically.

This module can be used to identify the physical ports by

determining the status when unplugging network connections.

Refer to Appendix C, Identifying Ports for further information.

A Status screen is provided, showing the following information:

■

NIC model number.

■

Kilobits per second (Kbps) transmitted per port.

■

Receive Kbps per port.

■

The present status of all ports and Failover Pairs.

– Active: This port is currently used for data transfer, and is

connected with data being sent and/or received.

– Idle: This port is currently used for data transfer, and is

connected with no data being sent or received.

– Standby: This port currently not used for data transfer, and

is connected with no data being sent or received.

– Down: Port is not connected, or the link is down.

– --NA--: Indicates a BNC connection. The BNC connector is

not supported by Duralink Failover.

F Keys

F1— provides on-line help for each screen.

F8— Changes the refresh interval. Refresh interval is a user-

selectable refresh cycle in seconds (default is 5 seconds). This is

the interval by which the utility will refresh the status.

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 121 122

Pas de commentaire

Adaptec PCI Ethernet and Fast Ethernet Adapters Guide de l'utilisateur Page 83