Adaptec PCI Ethernet and Fast Ethernet Adapters Guide de l'utilisateur télécharger pdf (Page 68)

9-6

Fast Ethernet Network Interface Cards

Configuring Failover Pairs

The following steps show how to group failover pairs. All available

ports are listed in the Available Adaptec Ports list box.

Assign a port to the Primary Ports list box by clicking on a port

in the Available Adaptec Ports list box to highlight the

selection.

Note:

The driver numbering schemes for the ports

(EMPCI1, EMPCI2, etc.) shown in the Configuration

screen are not associated with the physical PCI slot

numbers on the motherboard.

When a port has been highlighted, click on the top Add button.

The port moves to the Primary Ports drop-down box.

Assign a Backup port to the Primary Port by selecting a port

from the Available Adaptec Ports list box and clicking on the

bottom Add button. To remove a failover pair, select the port in

the Primary Ports drop-down box, and click Remove.

When you have completed setup of all failover pairs, click OK.

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 121 122

Pas de commentaire

Adaptec PCI Ethernet and Fast Ethernet Adapters Guide de l'utilisateur Page 68