Adaptec APA-1350 Guide d'installation télécharger pdf (Page 9)

ASI Hardware Installation Guide

Modifying the Jumpers on the Adaptec 1505 Card

Below is a picture of the Adaptec 1505 SCSI Host Adapter. The white arrow points to the area

of the card where the JUMPERS are located.

The arrow above points to the area on the card where the jumpers are located. The jumper

area is magnified below:

You need to change the jumpers on the card to match the settings that you wrote down earlier.

The following section shows you how to do this.

Changing the I/O Address of the 1505 Card

In order to change the I/O Address, you must start by modifying the I/O Address. The I/O

address jumper is the top-most set of pins, labeled ALT. The default position for the jumper is

OFF. (The term “OFF” means that the black plastic jumper is only mounted on one pin.)

When the top jumper is OFF, the I/O address is 340.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 33 34

Pas de commentaire

Adaptec APA-1350 Guide d'installation Page 9