Adaptec APA-1350 Guide d'installation télécharger pdf (Page 13)

ASI Hardware Installation Guide

In the back of your computer, locate the slot where the SCSI card was installed. The end of the

card should be sticking out of the back of the computer.

Take one end of the SCSI cable (that comes with your ASI package) and plug it into the card

that was just installed. Tighten the screws so that the cable is firmly connected to the card.

Below is a picture of the back of the DVD player. Plug the end of the SCSI cable into the TOP

port of the DVD player. (The other end of the cable is connected to the card you installed in

your computer.) Included in the DVD package there is a small gray connector, called a

“terminator”. Put the terminator on the BOTTOM port of the DVD player.

Plug the power cable into back of the DVD player, and turn the DVD player on.

Plug the power cable back into your computer, and turn your computer on. (If you had to

disconnect any other cables to install the SCSI card, you should reattach those cables at this

time.)

Once your computer boots up, proceed to the next section of this manual, “Confirming Proper

DVD Installation (PC User)”.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 33 34

Pas de commentaire

Adaptec APA-1350 Guide d'installation Page 13