Adaptec APA-1350 Guide d'installation télécharger pdf (Page 11)

ASI Hardware Installation Guide

Installing the Adaptec 1505 Card Into the Computer

After the 1505 card has been configured properly, place it into an available expansion inside

your computer.

Make sure your computer is turned off, and unplug the power cord.

NOTE: You should have a screwdriver handy before you begin installation of this card.

The next step is to remove the cover of your computer. Some computer systems have screws

located on the back of the case that you will need to remove in order to take off the cover. Note:

Only the outermost screws fastening the case to the box need to be removed. Some systems

require that the cover be pulled forward to remove it.

You may need to remove some screws to take the cover off your computer.

IMPORTANT! Before you touch any components inside the computer, touch the metal

case to ground yourself and discharge any static electricity that you may have

accumulated.

Once the cover is removed, locate a free expansion slot to place the Adaptec SCSI card.

There may be a screw holding the metal plate in place, unscrew it to remove the plate. Once the

plate is removed, you should be able to place the card into the slot, with the end of the card

sticking out the back of the computer. The picture on the next page displays a free computer

slot, with the metal plate removed.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 33 34

Pas de commentaire

Adaptec APA-1350 Guide d'installation Page 11