Adaptec 2930 - SCSI Card Ultra Storage Controller 20 MBps Manuel d'instructions télécharger pdf (Page 27)

Configuring the SCSI Card 2930U2 with SCSISelect

■ Support Removable Disks Under BIOS as Fixed Disks—

Determines which removable-media drives are supported by

the SCSI card BIOS. Choices are as follows:

■ Boot Only—Only the removable-media drive designated

as the boot device is treated as a hard disk drive.

■ All Disks—All removable-media drives supported by the

BIOS are treated as hard disk drives.

■ Disabled— No removable-media drives are treated as hard

disk drives. Software drivers are required because the

drives are not controlled by the BIOS.

Caution:

Do not remove a removable-media cartridge from a

SCSI drive controlled by the SCSI card BIOS while the drive

is on. You may lose data. To allow removability of the media

while the drive is on, install the removable-media software

driver and set Support Removable Disks Under BIOS as

Fixed Disks to Disabled.

■ Display <Ctrl> <A> Messages during BIOS Initialization—

When set to Enabled, the SCSI card BIOS displays the Press

<Ctrl> <A> for SCSISelect (TM) Utility! message on your screen

during system bootup. If this setting is disabled, you can still

invoke the SCSISelect Utility by pressing <Ctrl> <A> after the

SCSI card BIOS banner appears.

■ BIOS Support for Bootable CD-ROMs—When set to

Enabled, the SCSI card BIOS allows booting from a CD-ROM

drive.

■ BIOS Support for Int 13 Extensions—When set to Enabled,

the SCSI card BIOS supports Int 13h extensions as required by

Plug-and-Play. The setting can be either enabled or disabled if

your system is not Plug-and-Play.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 41 42

Pas de commentaire

Adaptec 2930 - SCSI Card Ultra Storage Controller 20 MBps Manuel d'instructions Page 27