Adaptec 2930 - SCSI Card Ultra Storage Controller 20 MBps Manuel d'instructions télécharger pdf (Page 11)

Troubleshooting

■ If there is an option to enable or disable bus mastering for

the PCI slots, select enable.

■ If there is an option to enable or disable individual PCI

slots, be sure the slot in which you install the SCSI Card

2930U2 is enabled.

■ If your computer has a combination of ISA (or EISA)

boards and PCI boards, you may need to mark the IRQs

used by ISA/EISA boards as Used so the computer BIOS

will not try to assign these IRQs to other PCI boards.

■ In some computers the BIOS reserves a set of available

IRQs for PCI boards, and you have to assign these IRQs

manually.

Note:

Some configuration options apply to a specific PCI bus

slot, so if you change any option be sure you are applying

the change to the correct slot. Check your computer docu-

mentation to determine the correct PCI bus slot.

Troubleshooting in Windows 95 and Windows 98

When I start Windows 95, the system locks up when the Windows logo

is displayed. How can I get the system to start so that I can verify that

the SCSI card is functioning normally?

Start or restart your computer. View the messages that appear

onscreen.

When the message “Starting Windows 95” appears, press and

release the F8 function key while the text is on your screen.

From the menu that is displayed, select Safe Mode. (It may

take several minutes for Windows 95 to load.)

If the system completes the boot to the desktop, the core soft-

ware is functional; resources, software conflicts and/or hard-

ware need to be checked.

If the system still fails to boot, and the boot drive is on an exist-

ing IDE or SCSI controller, shut down the system, remove the

SCSI Card 2930U2, and restart the computer.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 41 42

Pas de commentaire

Adaptec 2930 - SCSI Card Ultra Storage Controller 20 MBps Manuel d'instructions Page 11