Adaptec 2930 - SCSI Card Ultra Storage Controller 20 MBps Manuel d'instructions télécharger pdf (Page 15)

Troubleshooting

Common Error Messages

The following messages may appear at bootup:

“Device connected, but not ready”

The host received no answer when it requested data from an

installed SCSI peripheral.

■ Run SCSISelect and set the Send Start Unit Command to Ye s for

the particular SCSI peripheral ID.

■ Make sure the peripheral is set to spin up when the power is

switched on. The spin up option is typically set by a jumper.

(See the documentation for the peripheral.)

“Start unit request failed”

The SCSI Card BIOS was unable to send a Start Unit Command to

the peripheral.

■ Run SCSISelect and disable the Send Start Unit Command for

the peripheral.

“Time-out failure during...”

An unexpected time-out occurred.

■ Verify the SCSI bus is properly terminated.

■ Verify all cables are properly connected.

■ Try disconnecting the SCSI peripheral cables from the SCSI

card and then starting the computer. If the computer

successfully restarts, one of the SCSI peripherals may be

defective.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 41 42

Pas de commentaire

Adaptec 2930 - SCSI Card Ultra Storage Controller 20 MBps Manuel d'instructions Page 15