Adaptec 2930 - SCSI Card Ultra Storage Controller 20 MBps Manuel d'instructions télécharger pdf (Page 16)

SCSI Card 2930U2 User’s Reference

Using the SCSI Card 2930U2

and SCSI Peripherals

This section provides useful information on using the SCSI Card

2930U2 and your SCSI peripherals. For specific information, refer to

the SCSI peripheral documentation.

Using SCSI Peripherals

Hard Disk Drives

■

Every SCSI hard disk drive must be physically low-level for-

matted, partitioned, and logically formatted before it can be

used to store data. SCSI hard disks are physically low-level for-

matted at the factory and do not usually need to be formatted

again.

If you connect a new SCSI hard disk drive to your SCSI card,

you must partition and logically format the drive. For DOS

and Windows (3.x, 95, and 98) use the DOS

Fdisk

and

Format

commands (see your computer, DOS, and Windows documen-

tation). For Windows NT, see your operating system

documentation.

■

If you are booting from a SCSI hard disk drive, make sure the

Hard Disk (or Drives) setting in your computer’s CMOS setup

program is set to

None

No Drives Installed

, as is required

for SCSI hard disk drives. See your computer documentation

for details.

■

If both SCSI and non-SCSI (for example, IDE) disk drives are

installed, then the non-SCSI disk drive is typically the boot

drive. If your computer supports BBS (BIOS Boot Specifica-

tion), both SCSI and non-SCSI disk drives can coexist and you

can specify which drive to boot from. Refer to your computer

documentation for more information.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 41 42

Pas de commentaire

Adaptec 2930 - SCSI Card Ultra Storage Controller 20 MBps Manuel d'instructions Page 16