Adaptec 2100S - SCSI RAID Controller Guide de l'utilisateur télécharger pdf (Page 116)

4-8

RAIDUTIL Command Line Utility

Controller-Specific

-a Action (task) control

This switch has the following options which allow you to control

tasks on the controller:

Specify drives by the device address.

-F Update controller firmware, BIOS, or NVRAM

This option updates the controller flash memory (EEPROM). Specify

an image file name on the command line.

Note: The -F switch does not work on Novell NetWare

systems. Use SMOR to update the controller flash memory.

For additional information, see Chapter 2, Storage Manager

on ROM.

-X Reset NVRAM configuration

This option resets the controller NVRAM to the factory default

settings.

-Z Reset/clear embedded RAID information

This option destroys all RAID information pertaining to disk arrays

and logical drives for the specified device. Specify logical drives by

using the device address.

List Shows tasks for the controller

Build Starts build of logical drive

Rebuild Starts rebuild on logical drive

Verify Starts a verify operation

Stop Terminates active task on drive

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 134 135

Pas de commentaire

Adaptec 2100S - SCSI RAID Controller Guide de l'utilisateur Page 116