Adaptec 2100S - SCSI RAID Controller Guide de l'utilisateur télécharger pdf (Page 112)

4-4

RAIDUTIL Command Line Utility

Miscellaneous

-g Specify drive group

This switch identifies the physical drive to be used for array

creation, deletion, or modification. It must always be the last switch

in the array creation command sequence and it must always be

followed by a drive address as discussed in Device Address Syntax on

page 4-2.

Multiple drive addresses on a command line must always be

separated by commas.

This switch can also be used to introduce a list of comma-separated

drive addresses in any command that uses such addresses. When

creating multilevel RAID 0/1 or 0/5 arrays, separate drive groups

with a plus sign (+). The number of drives supported are listed

below:

Logical Drive Creation and Deletion

-c, -d Specify controller ID

This switch specifies the RAID controller to which all subsequent

parameters will apply. It is required for all operations. You can

specify a device which is attached to the controller, from which the

controller number will be derived, or you can enter the relative

controller number directly.

■ Use –c to specify the controller using the ID assigned to the

controller by your operating system.

■ Use –d to specify the controller ID in BIOS format. Adaptec

controllers are numbered starting from 0 according to their PCI

slot location. The boot controller or the controller in the lowest

number PCI slot is ID d0.

RAID 0

2 to 64 drives

RAID 1

2 to 64 drives (as pairs)

RAID 5

3 to 64 drives

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 134 135

Pas de commentaire

Adaptec 2100S - SCSI RAID Controller Guide de l'utilisateur Page 112