Adaptec 2200S - SCSI RAID Controller Guide d'installation télécharger pdf (Page 51)

3-20

Adaptec SCSI RAID 2120S/2200S Installation Guide

Adding the Controller to an Existing System

In this scenario, you are adding an Adaptec SCSI RAID controller

to an existing UnixWare 7or OpenUNIX 8 system.

To install the driver:

Shut down the system. Install and configure your Adaptec SCSI

RAID controller and hard disk drives according to the

instructions in Chapter 2.

Create the driver disk as shown at the beginning of this chapter.

Boot the system. After the system has booted, insert the driver

disk.

To run the installpkg utility, type installpkg -d disk/.

UNIX reads the disk and prompts you to enter the package

name to be installed.

Type aacraid_tar.z.

After the package is installed, rebuild the kernel when you are

asked if you wish to rebuild.

Restart the system.

Add devices to the controller.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 66 67

Pas de commentaire

Adaptec 2200S - SCSI RAID Controller Guide d'installation Page 51