Adaptec 2200S - SCSI RAID Controller Guide d'installation télécharger pdf (Page 49)

3-18

Adaptec SCSI RAID 2120S/2200S Installation Guide

Start the system and insert the installation CD for OpenServer 5.

Once the system starts loading from the CD, it will display a

Boot: prompt. When it does, insert the driver disk and type:

def bootstr link=aacraid

The system will continue the installation, using the driver

information from the driver disk. Continue the installation as

detailed in the instructions that came with OpenServer 5.

When the OpenServer installation completes, remove the driver

disk and reboot the system.

The boot driver installation process is complete.

Note:

You can run the drive_config utility only once.

OpenServer's method of statically configuring each driver

into the kernel can cause confusion for the user. The difficulty

arises from OpenServer's convention for naming drives. The

drive_config utility overcomes this limitation by

automatically creating the appropriate kernel entries and then

rebuilding/relinking the kernel. The drive_config utility

automatically creates device special files in the /dev/rdsk and

/dev/dsk directories. These files are named in the c#t#d#s#

(controller number, target number, disk number, fdisk

partition number) format. On a boot array, the files c0t0d0

and c0t0d0s0 point to the entire disk.

For information on disk partitioning conventions, visit

http://www.sco.com.

Adding the Controller to an Existing System

In this scenario, you are adding an Adaptec SCSI RAID controller

to an existing SCO OpenServer 5.x system.

To install the driver:

Install and configure your Adaptec SCSI RAID controller and

hard disk drives according to the instructions in Chapter 2.

Create a driver disk, see the beginning of this chapter.

Boot the server.

After the OpenServer system has booted, insert the driver disk.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 66 67

Pas de commentaire

Adaptec 2200S - SCSI RAID Controller Guide d'installation Page 49