Adaptec 2200S - SCSI RAID Controller Guide d'installation télécharger pdf (Page 18)

1-13

Introduction

■ Adaptec RAID Configuration utility (ARC)— Part of the

controller’s built-in BIOS code. You can start ARC by pressing

Ctrl+A during BIOS startup. For details, refer to Determining the

Booting Controller on page 2-7 or see the related chapter in the

Adaptec SCSI RAID Software User’s Guide.

■ Array Configuration Utility (ACU)--- A DOS application used

to create, configure, and manage arrays.

Safety Information

Any device that uses electricity must be treated with caution. To

ensure general safety, follow these guidelines:

■ Keep your work area and the computer clean and clear of

debris. Eliminate hazards such as spills or bad wiring.

■ Before opening the system cabinet, unplug the power cord.

Notes, Cautions, and Warnings

This Installation Guide uses notes, cautions, and warnings that

emphasize important information, as described below:

Note:

Emphasizes important information that, if ignored,

would not result in injury, property damage, or data loss.

Caution:

Emphasizes important information that, if ignored,

could cause equipment failure or loss of data.

Warning:

Indicates a hazard that could cause injury or property

damage.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 66 67

Pas de commentaire

Adaptec 2200S - SCSI RAID Controller Guide d'installation Page 18