Adaptec 2200S - SCSI RAID Controller Guide d'installation télécharger pdf (Page 43)

3-12

Adaptec SCSI RAID 2120S/2200S Installation Guide

If you intend to install other third-party devices, proceed with

the installation of those devices. Otherwise, select Done.

Continue with the Linux installation according to the Red Hat

documentation.

Installing the Driver in a New Red Hat 7.3 Linux System

In this scenario, you are installing the controller in a new Red Hat

7.3 Linux system.

To install the driver:

Install and configure your Adaptec SCSI RAID controller and

hard drives according to the instructions in Chapter 2.

Start the server. During startup, press Ctrl+A to start ARC. Use

ARC to create the RAID. For details, refer to Using the Adaptec

RAID Configuration (ARC) Utility on page 2-9.

Insert the Red Hat CD Disk 1 in the CD drive.

Start the system.

When the Red Hat welcome screen appears, type expert at the

boot prompt.

When prompted, insert the driver disk you created at the

beginning of this chapter and select OK.

Follow the prompts to set up your preferred environment.

If you intend to install other third-party devices, proceed with

the installation of those devices. Otherwise, select Done.

Continue with the Linux installation according to the Red Hat

documentation.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 66 67

Pas de commentaire

Adaptec 2200S - SCSI RAID Controller Guide d'installation Page 43