Adaptec 2200S - SCSI RAID Controller Guide d'installation télécharger pdf (Page 45)

3-14

Adaptec SCSI RAID 2120S/2200S Installation Guide

Novell NetWare

The Adaptec SCSI RAID Installation CD contains device drivers for

NetWare 5.1 and 6.x. The following Novell support packs are the

minimum level required before installing Adaptec SCSI RAID

controller software and drivers:

After you have installed the drivers, you can use the normal

NetWare procedures for modifying disk partitions, applying hot

fixes, or performing volume maintenance.

Adaptec Storage Manager-Browser Edition will not run on a

NetWare system. Creating and managing arrays on a NetWare

system may be done using any of the following:

■ Using ARC during the starting of the system.

■ Using the managed system components installed on the

NetWare system, and a remote Windows or Linux system

running Adaptec Storage Manager-Browser Edition.

■ Using Command Line Interface on the NetWare system in DOS

mode.

Installing the Driver for a Boot Controller in a New NetWare 5.1

or 6 Server

In this scenario, you are installing the Adaptec SCSI RAID

controller as a boot controller in a new NetWare 5.x or 6.x server.

To install the driver:

Install the Adaptec SCSI RAID controller as the primary

controller and attach the disk drives.

Start the server. During restart, press Ctrl+A to start ARC. Use

ARC to create the RAID. For details, refer to Using the Adaptec

RAID Configuration (ARC) Utility on page 2-9.

Install and configure a secondary controller, if any.

NetWare Revision Level Support Pack

5.1 5

6.0 2

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 66 67

Pas de commentaire

Adaptec 2200S - SCSI RAID Controller Guide d'installation Page 45