Adaptec 2010S - SCSI RAID Storage Controller Guide de l'utilisateur télécharger pdf (Page 31)

2-18

Adaptec Storage Management Software User’s Guide

Array and Array Group Information

The Information tab for any array may be viewed by highlighting

that array, as shown in Figure 2-8.

Figure 2-8 Array Group Information Tab

RAID 0 arrays are comprised of any number of drives greater than

1. RAID 1 arrays are comprised of a pair of drives. RAID 5 arrays

contain three or more drives.

After you create the arrays, one or more arrays of the same RAID

level can be combined into a multilevel RAID (see Creating a

Multilevel RAID on page 2-23). Arrays are striped into multilevel

RAIDs by the controller firmware. All the drives in an array or

multilevel RAID must be attached to the same controller, and

appear to the host as a single Logical Storage Unit (LSU).

Note: Arrays do not start building until a Set System Config

action has been performed.

The Array Information tab displays general array information and

hardware configuration. It is divided into three parts: Description,

SCSI Capabilities, and Status.

Combined RAID SW-UG.book Page 18 Monday, September 9, 2002 1:25 PM

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 127 128

Pas de commentaire

Adaptec 2010S - SCSI RAID Storage Controller Guide de l'utilisateur Page 31