Adaptec 2010S - SCSI RAID Storage Controller Guide de l'utilisateur télécharger pdf (Page 110)

4-11

RAIDUTIL Command Line Utility

-I Display inquiry information

This switch displays controller specific information, including

firmware revision, BIOS version, and serial number. Specify drives

by the device address.

-L List devices

Specify drives by the device address. The parameters for this

switch are listed below:

Note: If a controller is not specified then each controller is

listed, along with all devices on each controller.

Controller Displays a list of all Adaptec controllers in the

system.

Physical Displays all attached devices to the specified

controller.

Logical Displays a list of all logical drives on the controller,

by logical drive number.

Spare Displays a list of all stand-alone hot spare drives.

RAID Displays a list of all configured RAIDs.

Array Speed Displays a list of the bus speed of all connected

drives.

Redirect Displays any redirected devices.

Version Displays the controller firmware, SMOR, NVRAM,

and BIOS version numbers.

Cache Displays the device caching mode.

Inquiry Displays the device capabilities as reported to the

controller.

Battery Displays information about the battery backup

module.

All Prints out all of the above.

Combined RAID SW-UG.book Page 11 Monday, September 9, 2002 1:25 PM

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 127 128

Pas de commentaire

Adaptec 2010S - SCSI RAID Storage Controller Guide de l'utilisateur Page 110