Adaptec 2010S - SCSI RAID Storage Controller Guide de l'utilisateur télécharger pdf (Page 101)

4-2

Adaptec Storage Management Software User’s Guide

Exit Status

RAIDUTIL exits with either of the following error status

indications:

Device Address Syntax

When you use RAIDUTIL to specify a device or group of devices,

use an address of the form dDbBtTdD, where:

To list all devices on a particular bus, specify only dDbB. To list all

devices on a controller, specify only dD. To display device

information, use the List

(-L) command. Always separate drive

addresses with a comma.

0 Error-free termination

1 Error termination (the message log contains the error

information)

Controller ID.

Controller channel (or bus) number of the bus to which

the disks are attached. The range is 0 – 7.

Target ID of the disk. The range is 0-15.

the second “D”—Always zero.

Combined RAID SW-UG.book Page 2 Monday, September 9, 2002 1:25 PM

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 127 128

Pas de commentaire

Adaptec 2010S - SCSI RAID Storage Controller Guide de l'utilisateur Page 101