Adaptec 2010S - SCSI RAID Storage Controller Guide de l'utilisateur télécharger pdf (Page 107)

4-8

Adaptec Storage Management Software User’s Guide

Controller-Specific

-a Action (task) control

This switch has the following options which allow you to control

tasks on the controller:

Specify drives by the device address.

-F Update controller firmware, BIOS, or NVRAM

This option updates the controller flash memory (EEPROM).

Specify an image file name on the command line.

-X Reset NVRAM configuration

This option resets the controller NVRAM to the factory default

settings.

-Z Reset/clear embedded RAID information

This option destroys all RAID information pertaining to disk

arrays and logical drives for the specified device. Specify logical

drives by using the device address.

All specified drives become individual, unassigned physical drives

after this command is used.

Caution: There is no procedure to reverse the effect of the -Z

operation. This option is a method of last resort for deleting

conflicting RAID table information.

List Shows tasks for the controller

Build Starts build of logical drive

Rebuild Starts rebuild on logical drive

Verify Starts a verify operation

Stop Terminates active task on drive

Combined RAID SW-UG.book Page 8 Monday, September 9, 2002 1:25 PM

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 127 128

Pas de commentaire

Adaptec 2010S - SCSI RAID Storage Controller Guide de l'utilisateur Page 107