Adaptec 1542B - AHA Storage Controller Fast SCSI 10 MBps Guide d'installation Page 16
- Page / 127
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
• IRQ Level: 15
• I/O Address: 0x170
If an IDE CD-ROM drive is installed, the system BIOS parameter for that device
should be:
• Drive Type: Not installed
If an enhanced IDE drive is installed, set the system BIOS as follows:
• Enhanced IDE Drive: Enabled
Note - If the BIOS supports autoconfiguration, use this facility to set the number of
heads, cylinders, and sectors for the IDE hard disk drive. If this capability is not
supported by the BIOS, use the settings provided by the disk manufacturer.
Known Problems and Limitations
The Panasonic LK_MC579B IDE CD-ROM drive cannot be used to install the
Solaris operating environment and is not supported.
Several vendors ship PCI-equipped machines with IDE interfaces on the
motherboard. A number of these machines use the CMD-604 PCI-IDE controller.
This chip provides two IDE interfaces. The primary IDE interface is at I/O address
0x1F0 and the secondary interface at 0x170. However, this chip cannot handle
simultaneous I/O on both IDE interfaces. This defect causes the Solaris software to
hang if both interfaces are used.
Use only the primary IDE interface at address 0x1F0. Machines using this chip
include DELL XPS/90, HP XU/590C, and American Megatrends Atlas boards.
You cannot boot from the third or fourth IDE disk drives, although you can install
Solaris software on them.
The Solaris Volume Management software does not work with the Sony CDU-55E
CD-ROM drive no matter how it is configured (as the master or the slave).
Comment out the following line in the file /etc/vold.conf to prevent vold
from hanging the controller:
# use cdrom drive /dev/rdsk/c*s2 dev_cdrom.so cdrom%d
NEC CDR-260/CDR-260R/CDR-273, AZT CDR 268-031SE, Media Vision 6X, and
Sony CDU-55E ATAPI CD-ROM drives may fail during installation.
4
Device Reference Manual for Solaris 2.6 (Intel Platform Edition) ♦ April 1998
- Device Reference Manual for 1
- Contents 3
- Contents v 5
- Contents vii 7
- Contents ix 9
- Before You Read This Book 11
- Ordering Sun Documents 12
- Device Reference Pages 13
- Third-Party Drivers 13
- Using Device Reference Pages 14
- Disk Interface 15
- (Including ATAPI CD-ROM) 15
- • IRQ Level: 15 16
- • I/O Address: 0x170 16
- • Drive Type: Not installed 16
- • Enhanced IDE Drive: Enabled 16
- Device Reference Pages 5 17
- SCSI Host Bus Adapters 18
- 1530P, 1532P HBAs 18
- Interface 20
- Device Reference Pages 9 21
- 1542CF, 1542CP HBAs 22
- Device Reference Pages 11 23
- Adaptec AHA-1640, 1642 HBAs 24
- Adaptec AHA-1740, 1742A HBAs 25
- 2742W, 2840VL, 2842VL HBAs 26
- 3940UW, 3940AU, 3940AUW 29
- Device Reference Pages 19 31
- QLogic QLA510 HBAs 32
- BT-445S HBAs 33
- Special Cases 34
- Wide SCSI HBAs 38
- Device Reference Pages 29 41
- PM-3021 HBAs 42
- Device Reference Pages 31 43
- DPT PM-2012B HBA 44
- • Bus: Enabled 45
- • IDE Boot Address: Primary 45
- • Option ROM Address: Default 45
- • SCSI ID HBA: Default 7 45
- IBM Micro Channel HBA 46
- Adapter/A 47
- PCE-5 SCSI) 48
- 53C825A HBAs (DU 1) 49
- Subsystem HBAs 53
- SCSI RAID Controller (DU 2) 54
- 4. Reboot 55
- Compaq SMART Array Controller 56
- Compaq SMART-2, SMART-2SL 57
- SMART-2DH Array Controllers 57
- PM-2142W SCSI and PM-3222 58
- PM-3332UW SCSI RAID HBAs 58
- PM-2124, PM-2124W, PM-2144W 60
- PM-2144UW SCSI and PM-3224 60
- PM-3224W, PM-3334W, PM-3334UW 60
- SCSI RAID HBAs 60
- Supported Settings 61
- IBM PC ServeRAID SCSI HBA 62
- Graphics Cards 65
- Intergraph G91 65
- Device Reference Pages 55 67
- Ethernet Network Adapters 68
- 3Com EtherLink 16 (3C507) 68
- II/16 (3C503-16) 69
- Device Reference Pages 61 73
- NetFlex-2 ENET-TR Controllers 74
- Device Reference Pages 63 75
- Compaq NetFlex-3, Netelligent 76
- Controllers 76
- # touch /reconfigure 78
- # reboot 78
- Ethernet (DU 3) 79
- Device Reference Pages 69 81
- MCA TP (82586) 83
- Device Reference Pages 77 89
- Novell NE3200 Ethernet 90
- Ethernet 91
- SMC Elite32 (8033) 93
- SMC Elite32C Ultra (8232) 94
- SMC Ether 10/100 (9232) 95
- 32T (8033) 96
- 0x260 5 0xE0000 97
- 0x380 7 0xD4000 97
- Token Ring Network Adapters 100
- Ring and Compatible Adapters 100
- Configuration Procedure 101
- Preconfiguration Information 103
- Audio Cards 105
- Analog Devices AD1848 and 105
- Compatible Devices 105
- Device Reference Pages 95 107
- Blaster Pro-2 109
- • IRQ Level: 2, 5, 7,10 110
- • I/O Address: 110
- 0x220, 0x240 110
- • DMA Channel: 0, 1,3 110
- PC Card (PCMCIA) Hardware 113
- PC Card Adapters 113
- Device Reference Pages 103 115
- Configuring Two or More Cards 117
- Special Files 118
- Hot-Plugging 118
- Additional Configuration 121
- SRAM and DRAM PC Card Devices 122
- Using PC Card Memory Devices 124
- PC Card ATA Devices 125
- # newfs /dev/rdsk/c#d#s# 127
Produits connexes et manuels pour Logiciel Adaptec 1542B - AHA Storage Controller Fast SCSI 10 MBps
(9 pages)
(2 pages)© 2020, manymanuals.fr. Tous droits réservés | 0.059 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels