Adaptec APA-1460A Manuel d'utilisateur télécharger pdf (Page 16)

APSoft

8 Command Line Options. APA-1460 Enabler for DOS

/HI:n

Specifies the Host Adapter SCSI ID (0 - 7).

/DI:<use>

Allow SCSI targets to disconnect during command execution.

/SN:<use>

Enable the Host Adapter to initiate negotiation with the target for

synchronous data transfer.

/PA:<use>

Enable SCSI bus parity check by the Host Adapter.

Unloading

/UL

Unload resident part (not supported, if driver is loaded via config.sys)

EN1460 and UN1460 Specific Options

Following command line options are for EN1460 and UN1460 only. Using

them the user may override the default base address of the PC Card adapter or

override the default socket number.

In case of UN1460: Parameters only apply to non-CardBus sockets.

/B:n PCMCIA adapter base I/O address (Default: 0x03E0)

/S:n PCMCIA socket number (Default: 0)

Please notice, that if you want to support more than one non-CardBus socket

using EN1460 or UN1460, you will have to create an INI file.

CB1460 and UN1460 Specific Options

Following command line options are for CB1460 and UN1460 only. Using

them the user may control the initialization of CardBus sockets.

On most of recently made notebooks the BIOS will configure the interrupt

mode properly. You should not specify /PI, /MI, /MX and /OZ options unless

you are sure that the interrupt mode is not set properly.

/PI:n

PCI Interrupt level (Default: 0x0B)

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Pas de commentaire

Adaptec APA-1460A Manuel d'utilisateur Page 16