Adaptec APA-1460A Manuel d'utilisateur télécharger pdf (Page 11)

APSoft

APA-1460 Enabler for DOS Installation 3

Memory Requirements

All versions of APA-1460 Enablers require 4 kB of memory to access the SCSI

Card Information Structure (CIS). This memory is required only during

initialization.

In addition CB1460 and UN1460 require 4 kB of memory per CardBus socket

to establish the memory access to CardBus registers. This memory is required

only during initialization.

The required memory should not be shadowed by BIOS and should be excluded

from memory management by EMM386.EXE if you load APA-1460 Enabler

after EMM386.EXE.

Most computers provide such non-shadowed memory at address 0xD0000, so

by default all APA-1460 Enablers will use the address above. However of some

machines, the address above may be used by another hardware. In this case,

APA-1460 Enabler allows modify used memory address via command line.

You can invoke APA-1460 enabler in the any point. For example:

…

DEVICE=C:\UN1460.EXE /M:0xD4000 /CI:10

DEVICE=C:\DOS\HIMEM.SYS /TESTMEM:OFF

DEVICE=C:\DOS\EMM386.EXE NOEMS X=0xED00-0xEFFF

DOS=HIGH,UMB

…

DEVICEHIGH=C:\ASPI2DOS.SYS /D /PCMCIA /Z /Q10 /P340

…

Special Note for Toshiba Notebooks.

If you are using EN1460 on Toshiba notebooks please make sure that you set

the PC Card adapter either to Auto-Select mode, or to PCIC mode via BIOS

setup. The CardBus/PC-Card 16 mode is not supported. When using CB1460

please make sure that you set the PC Card adapter to CardBus/PC-Card 16

mode. The PCIC and Auto-Select modes aren't supported. `The UN1460 works

in either mode.

Fine-tuning

The fine-tuning could be performed either in standard installation mode via

command line options, or in advanced installation mode via an external INI file.

Example of

config.sys

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Pas de commentaire

Adaptec APA-1460A Manuel d'utilisateur Page 11