Adaptec ULTRA160 Guide de l'utilisateur télécharger pdf (Page 27)

2-15

Microsoft Windows NT Installation

[xxxxx023] Target device parity error

The driver has detected a parity error by the target device.

[xxxxx024] Data overrun or underrun

The adapter was given more or less data than the expected amount

of data.

[xxxxx031] Target device queue full

The target device internal buffer is full.

[xxxxx032] Target device busy

The target device reports a Busy status. Another program may

already be using this device.

[xxxxx050] Host adapter failure

[xxxxxx9A] Host adapter failure

Your host adapter may not be properly installed or is defective. Try

resetting the adapter in the PCI slot, or try installing it a different

PCI slot.

[xxxxx081] Adapter initialization failure

[xxxxxx8A] Adapter initialization failure

[xxxxxx83] Adapter initialization failure

An error has occurred while the driver was setting up its internal

data structures. Verify that your adapter is supported by this version

of the driver.

[xxxxx089] Unable to allocate memory

This indicates that there may be a problem with the amount of

memory installed in your system. Verify that your system has at

least the minimum amount of memory required by your operating

system.

[xxxxx096] Adapter hardware initialization failure—possible resource conflict

The driver has attempted to initialize the adapter hardware but

failed. This might suggest that the adapter resources (e.g., IRQ)

conflict with another board installed in your system.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 77 78

Pas de commentaire

Adaptec ULTRA160 Guide de l'utilisateur Page 27