Adaptec 1210SA - Serial ATA RAID Controller Guide de l'utilisateur télécharger pdf (Page 20)

2-2

Installing the Controller

To install the controller in the system cabinet:

1 Shut down your computer and disconnect the power cord.

2 Open the computer cabinet and identify an unused PCI slot.

3 If your computer accepts low-profile brackets only, install the

low-profile bracket supplied with your kit.

4 Identify an unused PCI slot and remove the slot cover, as

illustrated below.

5 Install the controller in the PCI slot and secure the controller

bracket to the host system cabinet.

6 If you have not already installed your Serial ATA hard drives,

do so now.

7 Use the cables supplied with your kit to connect your controller

to the Serial ATA hard drives.

The connectors at each end of a cable are the identical; therefore,

it does not matter which end you connect to your controller or

hard drive. Also, the connectors are keyed so that they only fit

the connector in one direction. Do not try to force a cable on to

the controller or a drive. If the connector does not slide on

easily, try reversing it.

8 Close the computer cabinet and re-attach the power cord.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 87 88

Pas de commentaire

Adaptec 1210SA - Serial ATA RAID Controller Guide de l'utilisateur Page 20