Adaptec SATA AND SCSI RAID CONTROLLERS Manuel d'utilisateur télécharger pdf (Page 32)

2-4

Installing the Controller and Drives

Determining the Boot Controller

Note: If your system will contain two or more bootable

controllers, read this section. Otherwise, skip this section.

The Adaptec RAID controller supports bootable drives and arrays.

The default setting of the controller and system Setup usually allows

you to install and boot from either a hard drive connected to the

motherboard, or from a drive or array connected to the controller.

If you already have an operating system installed on a hard drive

connected to the motherboard and you want to boot a second

operating system from the RAID controller:

1 Enter the system Setup.

2 Navigate to the hard drive boot sequence.

3 Move the boot controller to the top of the list.

Creating a Bootable RAID 5 Array

Note: If you want to install an operating system on a drive or

array connected to your Adaptec RAID controller, read this

section. Otherwise, skip to installing the driver in your

existing operating system, as described in Chapter 3.

This section describes how to create a bootable RAID 5 array with

at least three drives.

The following methods are described. Choose the method you prefer:

■ Using the Adaptec RAID Configuration (ARC) Utility—Use this

method if you prefer a text-based approach.

■ Using the Adaptec Installation CD—Use this method if you prefer

a graphical interface-based approach.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 164 165

Pas de commentaire

Adaptec SATA AND SCSI RAID CONTROLLERS Manuel d'utilisateur Page 32