Adaptec 6405 Guide de l'utilisateur télécharger pdf (Page 34)

Remove mounting

screws with Phillips

screw driver

Front of board

Figure 2

Back of board

Figure 1

2. Attach the low-prole bracket to the controller board. The low-prole bracket is installed on the

back side of the controller, with the mounting screws inserted from the front of the controller, as

shown the Figure 3.

Insert the screws through the holes on the front of the controller, then fasten the screws to the

bracket with a Phillips screw driver.

Caution: The mount points on the low-prole bracket have a smooth or at side

and a raised side that looks like a spacer (see Figure 3). Be sure to install the bracket

with the at side against the controller PCB and the raised side facing away from

the PCB.

Figure 3

Raised side of bracket

Front of board

Flat side of bracket

Back of board

Caution: The torque on the mounting screws should be a maximum of 3.0-4.0

lbf-in to avoid deformation. Be sure that the controller is not bent after attaching

the low-prole bracket to the controller board.

Installation Options

When you install your Adaptec RAID controller, you can choose to create a bootable array and then

install your operating system and the controller driver on that array.

Alternatively, you can complete a standard installation, where the controller driver is installed on an

existing operating system.

Basic Installation Steps

This section describes the installation process. Follow the steps for the installation option you’ve chosen.

34Proprietary and Condential to PMC-Sierra, Inc.

Document No.: CDP-00277-02-A Rev. A, Issue:

Serial Attached SCSI RAID Controllers Installation and User's Guide

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 109 110

Pas de commentaire

Adaptec 6405 Guide de l'utilisateur Page 34