Adaptec 2110S - SCSI RAID Controller Guide d'installation télécharger pdf (Page 64)

3-29

Installing the Driver

Adding the Controller to an Existing UnixWare 7 System

In this scenario, you are adding an Adaptec RAID controller to an

existing UnixWare 7 system. To install the driver

1 Install and configure your Adaptec RAID controller and hard

drives according to the instructions in Chapter 2.

2 Download the latest I

O supplement for UnixWare 7 from the

SCO Web site—it should be

ptf7066c or higher.

3 Uncompress the PTF file you downloaded in Step 2 and move

the file to the

/tmp directory.

4 Use the pkgadd utility to install the I

O supplement by typing:

pkgadd -d /tmp/ptf7066c

5 Follow the on-screen prompts to install the SCO UnixWare I

supplement.

6 Shutdown and restart the system.

Note: Upon restarting, several warning messages may

appear and scroll off the screen quickly. These will not occur

after diskadd is run and can be ignored.

7 Use the diskadd utility to add drives or arrays that are attached

to an Adaptec RAID controller.

8 If you need to add devices to a secondary controller, open a

terminal window and type sdiconfig -l. This utility

returns the device address for all controllers recognized by the

operating system and any attached devices. (You will need this

information to perform Step 9.) The device address is of the

format cCCbBBtTTdDD, where

■ CC specifies the controller ID.

■ BB is the controller channel (or bus) number of the bus to

which the disks are attached. The range is 0 - 7.

■ TT is the target ID (TID). The range is 0 - 31.

■ DD (the second “D”) is always zero.

COMBINED RAID IG.BOOK Page 29 Tuesday, September 25, 2001 5:46 PM

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 105 106

Pas de commentaire

Adaptec 2110S - SCSI RAID Controller Guide d'installation Page 64