Adaptec 2110S - SCSI RAID Controller Guide d'installation télécharger pdf (Page 40)

3-5

Installing the Driver

Upgrading Windows NT to Windows 2000

In this scenario, you already have an Adaptec RAID controller

installed in your system. However, because you are upgrading to a

new operating system, you need to put the correct driver into the

new operating system. To install the driver

Create a driver floppy disk using the

Adaptec RAID Installation CD

To create the disk

a Insert the Adaptec RAID Installation CD in your drive.

b Start from the CD. The CD loads a Linux kernel that is used

to manage all of its functions.

c Follow instructions and respond to prompts as necessary to

get to the Adaptec splash screen.

d When you see the Adaptec splash screen, click Create

Driver Disk. Then, click the appropriate operating system.

e Insert a floppy disk and click OK. The system creates the

driver disk.

2 Shut down the system and remove the Adaptec RAID

Installation CD.

3 Restart the system.

4 Click the Windows Start button, select Run, and type

a:\w2kprep.exe

5 Remove the driver disk.

6 Insert the Windows 2000 CD and run the setup.exe program.

Setup copies some files and then restart the system.

COMBINED RAID IG.BOOK Page 5 Tuesday, September 25, 2001 5:46 PM

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 105 106

Pas de commentaire

Adaptec 2110S - SCSI RAID Controller Guide d'installation Page 40