Adaptec Storage Manager Manuel d'utilisateur télécharger pdf (Page 152)

Chapter 16: Solving Problems ● 151

Rebuilding Logical Drives

A hot-swap rebuild occurs when a controller detects that a failed disk

drive in a logical drive has been removed and then reinserted.

To start a hot-swap rebuild:

1 Following manufacturer’s instructions, gently pull the failed disk

drive from the server without fully removing it, then wait for it to

spin down fully before continuing.

2 If there is nothing wrong with the disk drive, reinstall it, following

manufacturer’s instructions.

If necessary, replace the failed disk drive with a new disk drive of

equal or larger size.

3 The controller detects the reinserted (or new) disk drive and begins

to rebuild the logical drive.

Solving Notification Problems

To test notifications on your storage space, you can send test events or

emails to ensure that they’re being received properly.

If your test event fails:

1 Ensure that the remote system is powered on and running Adaptec

Storage Manager.

2 Open the remote system’s System Properties window (see Step 3 on

page 107) and double-check the TCP/IP address and port number.

3 Try sending the test event again.

If your test email fails:

1 Ensure that the recipient’s email address is correct. (See Modifying a

Recipient’s Information on page 115 to modify the address.)

2 Ensure that your SMTP server address is correct. (See Changing the

Email Notification Manager Settings on page 118 to modify the

address.)

3 Try sending the test message again.

1 2 ... 147 148 149 150 151 152 153 154 155 156 157 ... 190 191

Pas de commentaire

Adaptec Storage Manager Manuel d'utilisateur Page 152