Adaptec Storage Manager Manuel d'utilisateur télécharger pdf (Page 145)

Chapter 15: Managing Controllers and Disk Drives ● 144

7 Review the update summary, then click Apply.

8 When prompted, click Yes to begin the update.

Caution: Do not power down the controller(s) during the

update.

9 When the update is complete, click OK. Then, restart the server(s) to

activate the new firmware images.

Setting a Disk Drive to ‘Failed’

Before you can remove a disk drive from a server, you must set it to a

failed state to protect your data.

Caution: You may lose data or damage your disk drive if you

remove a disk drive without first setting it to a failed state.

You can set a disk drive to a failed state if:

● The disk drive is not part of a logical drive, or

● The disk drive is part of a redundant, healthy logical drive

You can’t set a disk drive to a failed state if doing so will take a logical

drive offline.

To set a disk drive to a failed state:

1 In the Physical Devices View, click the disk drive.

2 In the menu bar, select Actions, then click Set drive state to failed.

3 Click Ye s to set the drive status to failed.

4 Remove and replace the disk drive.

5 If the logical drive that the disk drive belongs to is failed, see

Recovering from a Disk Drive Failure on page 147.

1 2 ... 140 141 142 143 144 145 146 147 148 149 150 ... 190 191

Pas de commentaire

Adaptec Storage Manager Manuel d'utilisateur Page 145