Adaptec AHA-2940UKIT Guide de l'utilisateur télécharger pdf (Page 8)

board. SCSISelect also contains SCSI disk utilities

that let you low-level format or verify the disk media

of your SCSI hard disk drives.

SCSI

Select

Default Settings

The AHA-2940Ultra/2940Ultra Wide has the default

settings shown in the table on the following page.

The default settings are appropriate for most PCI

systems. If you do not need to change any of the

default settings, there is no need to run SCSISelect.

Your host adapter is ready for operation and you can

proceed to Installing Device Drivers on page 10.

For situations where you might want or need to

change the settings, see the descriptions of each set-

ting in the user’s guide. If you need to change any of

the default settings, or if you would like to format or

verify a disk, see Starting the SCSISelect Utility on

page 9 to start the utility.

SCSI Bus Interface Definitions Default

Host Adapter SCSI ID 7

SCSI Parity Checking Enabled

Host Adapter SCSI Termination Automatic

Boot Device Options Default

Boot SCSI ID 0

Boot LUN Number

SCSI Device Configuration Default

Maximum Sync Transfer Rate 20.0 MBytes/sec

40.0 MBytes/sec

Enable Disconnection Yes (Enabled)

Initiate Wide Negotiation

Yes (Enabled)

Send Start Unit Command

Yes (Enabled)

Enable Write Back Cache N/C (No change)

BIOS Multiple LUN Support

No (Disabled)

Include in BIOS Scan Yes (Enabled)

Advanced Configuration Options Default

Plug and Play SCAM Support Disabled

Reset SCSI Bus at IC Initialization Enabled

Extended BIOS Translation for DOS Drives >

1 GByte

Enabled

Verbose/Silent Mode Verbose

Host Adapter BIOS (Configuration Utility

reserves BIOS space)

Enabled

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Commentaires sur ces manuels

Pas de commentaire

Adaptec AHA-2940UKIT Guide de l'utilisateur Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Cartes/adaptateurs d'interface Adaptec AHA-2940UKIT