Adaptec Ultra Wireless Wireless Access Point Manuel d'utilisateur télécharger pdf (Page 14)

Installing Your Wireless AP

Installing the Wireless AP

Your Wireless AP can fit into your WLAN in multiple ways. It can

be connected to a hub or switch on your network, a router on your

network, or a network adapter that’s installed in a computer on

your network.

To install the Wireless AP:

1 Use the mounting screws to secure the Access Point in place, if

desired.

2 Connect the Ethernet cable to the LAN port on the Access Point.

3 Depending on your network configuration, connect the other

end of the Ethernet cable to the LAN port on:

■ a hub or switch on your network.

■ a router on your network.

■ a network card installed in another computer on your

network.

4 Connect the power adapter to the DC-IN port on the Access

Point (as shown in Step 2 on page 7), and plug it into a power

outlet.

5 Raise the Access Point’s antennas.

Your Wireless AP is installed. See Installing the Wireless Access Point

Utility on page 8 to continue with your next Installation task.

Step 2:

Connect LAN.

Step 4:

Connect power.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 44 45

Pas de commentaire

Adaptec Ultra Wireless Wireless Access Point Manuel d'utilisateur Page 14