Adaptec Ultra Wireless Ultra Wireless Access Point Guide de l'utilisateur télécharger pdf (Page 27)

Changing the Set-up of Your WLAN

Changing the Set-up of

Your WLAN

You can use the Wireless Access Point Utility

to change the set-up

of your WLAN by:

■ Changing the transfer rate. See page 21.

■ Changing the encryption (WEP) settings. See page 22.

■ Limiting access to your Wireless AP by filtering MAC

addresses. See page 25.

■ Changing the Administration password. See page 26.

Note: Adaptec recommends that you manage your

Wireless AP from a computer that is physically connected

to your Wireless AP through a network hub, switch, or

router, not connected over the Wireless network. It is

better to manage your Wireless AP from a wired

connection.

You can also use a web browser to make these changes if you know the IP

address of your Wireless AP.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 44 45

Pas de commentaire

Adaptec Ultra Wireless Ultra Wireless Access Point Guide de l'utilisateur Page 27