Adaptec 1542CP - Storage Controller Fast SCSI 10 MBps Guide de l'utilisateur télécharger pdf (Page 105)

100

101

A-63054 February 2004 3B-23

Setting up the scanner You can set up or change the parameters of the scanner you will be using by

accessing the Setup dialog box.

1. Select Scanner>Setup.

The Scanner Setup dialog box appears.

A check in the

Energy saver mode

box indicates that automatic lamp shutoff is

enabled. Specify the time that the scanner will wait after the last scan operation

before it shuts off the lamps. Valid values are 1 to 60 minutes.

The

Emulation mode

check box is used to enable/disable running

Capture Software in emulation mode without an attached scanner. For more

information on the Emulation mode check box, refer to Appendix A, Installation.

NOTE: If the Emulation mode setting is changed, you may need to exit and

restart Capture Software in order to scan successfully.

2. Press the About button to display information about the attached scanner.

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 411 412

Commentaires sur ces manuels

Pas de commentaire

Adaptec 1542CP - Storage Controller Fast SCSI 10 MBps Guide de l'utilisateur Page 105

Commentaires sur ces manuels