Adaptec SAS/SATA/SCSI RAID Controllers Manuel d'utilisateur Page 43

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 112
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 42
Chapter 7: Installing the Driver and an Operating System 43
Before You Begin
Install and connect your Adaptec RAID controller and internal disk drives (see page 31).
Create a bootable array (see page 37).
Create a driver disk (see the following section).
Creating a Driver Disk
Note: You will need a floppy disk to complete this task.
To create a driver disk:
1 Set your system BIOS so that your computer boots from the CD drive. (For instructions,
refer to your computer’s documentation.)
2 Turn on your computer, then insert the RAID Installation CD included in your RAID
controller kit.
3 Follow the on-screen instructions to get to the Adaptec Start Menu.
4 Click Create Driver Disk(s) for Installing/Updating your OS, then select your operating
system.
Windows
Linux
NetWare
OpenServer
Solaris
UnixWare
Note:
Linux only—If prompted, select your operating system and then the version.
5
When prompted, insert a floppy disk, then click OK.
The system creates the driver disk.
6 Remove and label the driver disk.
7 Continue with the instructions for your operating system:
For Windows, see page 44.
For Red Hat Linux, see page 44.
For SUSE Linux, see page 45.
For NetWare, see page 45.
For OpenServer, see page 46.
For Solaris, see page 46
For UnixWare, see page 47.
For VMWare, see page 47.
For FreeBSD, see page 47.
Vue de la page 42
1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 111 112

Commentaires sur ces manuels

Pas de commentaire