Adaptec USB2connect Host Bus Adapter Manuel d'utilisateur télécharger pdf (Page 4)

4 of 9

To install the Gerber USB-to-Parallel Cable and Driver

Note: You must have Administrative privileges to install the Gerber USB-to-Parallel driver on

your system.

1 Be sure the GERBER EDGE/EDGE 2 is powered off. Connect the parallel (Centronics)

end of the cable into the back of the GERBER EDGE/EDGE 2.

2 Connect the USB end of the cable into the USB port of your computer. Windows

should detect the new device and display the “Found new hardware: USB device”

message on the Windows task bar.

3 When Windows displays the Found New Hardware Wizard, select “No, not at this

time” (for Windows XP only) and then click Next.

Windows XP Windows 2000

4 When the following dialog box displays, insert the USB-to-Parallel Installation CD into

the CD Rom drive of your computer. Select the option shown in the following

illustrations and click Next.

Windows XP Windows 2000

5 When the following dialog box displays, turn on “Search removable media (floppy

CD-ROM…” or “Optional search locations: CD-ROM drives” and click Next.

1 2 3 4 5 6 7 8 9

Pas de commentaire

Adaptec USB2connect Host Bus Adapter Manuel d'utilisateur Page 4