Adaptec PCI Ethernet and Fast Ethernet Adapters Manuel d'utilisateur télécharger pdf (Page 45)

4-17

Installing Network Drivers

PCI Ethernet and Fast Ethernet Adapters User’s Guide

Stock Number: 511472-00, Rev. A Page: 4-17

Print Spec Number: 496708-00

Current Date: 5/5/97 ECN Date: 5/97

■

100 Mb/s/Full Duplex

Forces the connection to 100 Mb/s in Full Duplex mode.

■

THIN

Use this when connecting to the BNC port of a Combo

adapter. This is a 10 Mb/s Half Duplex only connection.

■

THICK

Used for an adapter that uses an AUI port.This is a 10-

Mb/s Half Duplex only connection.

Note:

Be sure to select the appropriate cable type for your

network. Also, be sure that both failover ports have been

configured to use the same connection type.

Click Continue.

Repeat step 17 for each Adaptec adapter installed in your

system. Each adapter can be identified by its unique PCI

Bus/PCI Slot number.

If SNMP has not been set up on this computer you will receive

the following Setup Message: Install the NT SNMP service

and use configure option to configure Server related MIBs.

Click OK.

Configuring the Primary and Backup Ports

Highlight the Adaptec adapter that you want as a primary

adapter. Click Properties.

In the Failover section in the Duralink Setup by Adaptec dialog

box, click Configuration.

In the Available Backup Ports section in the Duralink Failover

Manager dialog box, highlight the adapter you want as a

backup and click Add.

The Link Check Timeout value is the number of seconds that

elapse between Duralink’s checks for failure of the active link.

You can change this value or leave the default at 10.

Click OK to close the Duralink Failover Manager.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 87 88

Pas de commentaire

Adaptec PCI Ethernet and Fast Ethernet Adapters Manuel d'utilisateur Page 45