Adaptec USBConnect2000 Guide de l'utilisateur télécharger pdf (Page 9)

Installing the USBConnect 2000 adapter

Installing the USBConnect

2000 adapter

The following information describes the hardware and software

installation for the USBConnect 2000 adapter.

Hardware Installation

Follow these steps to install the USBConnect 2000 adapter:

Remove the USBConnect 2000 adapter from its packaging.

Connect the USBConnect 2000 adapter into the SCSI device

you want to connect.

Connect the USB connector (small end) into your systems USB

port. (See diagram below.)

If attaching the USBConnect 2000 adapter through a USB hub,

we recommend using A/C powered hubs.

Note:

The USBConnect 2000 adapter receives its +5V

power from the terminator power line of the attached SCSI

device. See

Terminating the SCSI Bus

, on page 8.

USB Port

USB Connect

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 25 26

Pas de commentaire

Adaptec USBConnect2000 Guide de l'utilisateur Page 9