Adaptec 2100S - SCSI RAID Controller Guide d'installation télécharger pdf (Page 96)

100

D-1

Controller Reset Procedures

In this Appendix

This Appendix describes procedures that you can use to reset your

controller in the event the controller becomes inoperable for the

reasons described below:

■ NVRAM Reset—The controller was improperly configured.

■ Flash Mode 0—An upgrade to the controller was attempted,

but failed.

➤

✮✶✲✡✭ ✲❅▲❅▼ ✤ ✒

➤

✦●❁▲❈ ✭❏❄❅ ✐ ✤ ✒

1 2 ... 91 92 93 94 95 96 97 98 99 100

Adaptec RAID 1
Copyright 2
Trademarks 2
Disclaimer 2
Canadian Compliance Statement 4
Contents 5
3 Installing the Driver 6
A Card and Module Diagrams 8
B Controller LEDs 8
C Troubleshooting 8
E Specifications 8
Read this First 10
System Requirements 10
Kit Contents 11
■ Active termination 13
About the Documentation 14
Introduction 15
Files and Folders 16
Product Documentation on CD 17
Errata and Release Notes 17
Cache Memory Module 20
Safety Information 23
Installing Your Controller 25
Configuring SCSI Devices 26
LVD and SE Devices 27
SCSI Cables 27
SCSI Device IDs 27
SCSI Termination 28
Seating the Module 30
Adaptec 3200S/3400S Only 30
Finishing up – All Models 31
Installing the Controller 32
Controller IRQ and Address 33
Using SMOR 34
4 Exit SMOR 35
Installing the Driver 36
Windows 2000 37
WindowsNT4.0 40
Controller 41
Creating the Driver Disk 46
CD-ROM Support 46
C drive 47
(OEM SR2 – Version 95B) 49
Novell NetWare 53
NetWare 4.11 Server 54
NetWare 4.2 Server 56
C drive named nwupdate 57
NetWare 5 Server 59
SCO UNIX 61
OpenServer 5.x System 62
Installing Storage 68
Management Software 68
Installation Prerequisites 70
NetWare 4.11 and 4.2 71
NetWare 5.x 73
Red Hat Linux and FreeBSD 74
Installing Storage Manager 75
SCO UnixWare 7 77
■ K Desktop Environment (KDE) 78
Card and Module Diagrams 79
Adaptec ATA RAID 2400A 80
Adaptec SCSI RAID 2100S 81
Adaptec SCSI RAID 3200S 82
Adaptec SCSI RAID 3400S 83
Adaptec SCSI RAID 3210S/3410S 84
Adaptec Battery Backup Module 86
Controller LEDs 87
LED During Power-up 88
LEDs During Controller Idle 88
LEDs During Controller Active 88
Cache Status LEDs 89
SCSI Bus Status LEDs 90
Troubleshooting 92
Controller Reset Procedures 96
NVRAM Reset 97
Flash Mode 0 97
Specifications 99
Adaptec, Inc 100
691 South Milpitas Boulevard 100
Milpitas, CA 95035 100

Commentaires sur ces manuels

Pas de commentaire

Adaptec 2100S - SCSI RAID Controller Guide d'installation Page 96

Commentaires sur ces manuels

Produits connexes et manuels pour Cartes mères Adaptec 2100S - SCSI RAID Controller