Adaptec FC4100 Manuel d'utilisateur télécharger pdf (Page 7)

3 Remove the tower’s front bezel, as shown below, saving the

screws for use in Step 5.

4 Turn the enclosure 90° so that the right hand rack mount ear

and LEDs are on top, then slide the Storage Enclosure into the

tower skin, as shown above.

5 Replace the front bezel, using the screws removed in Step 3.

6 Install the tower labels at the top and bottom of the tower. Align

the holes in the top label with the LEDs on the enclosure.

7 Replace the drive carriers and APCs, if necessary.

The tower assembly installation is complete. Continue with Step 2:

Installing the Drive Carriers, below.

Step 2: Installing the Drive Carriers

These instructions assume that the drive carriers have already been

attached to your disk drives.

Caution: Acclimate new disk drives to room temperature

before you install them and power up the Storage Enclosure.

To install the drive carriers into the Storage Enclosure:

1 Hold the drive carrier with the LEDs on the left side (at the

bottom for tower-mounted systems) and select an open disk

drive slot.

Note: It is easiest to install the drive carriers from left to

right on the Storage Enclosure.

Step 3 Step 4

1 2 3 4 5 6 7 8 9 10 11 12 13

Pas de commentaire

Adaptec FC4100 Manuel d'utilisateur Page 7