RAdaptec ASH-1233ATA AdapterInstallation GuideASH-1233 ATA Card IG.fm Page -1 Thursday, April 15, 2004 2:14 PM
9Connecting One ATA Disk Drive on a CableWhen you connect only one ATA disk drive to a cable, that disk drive must be set as a master drive. (See Sett
102 Connect the other end of the IDE cable to a master drive, as shown below on the left.3 Repeat Step 1 and 2 to connect a second ATA disk drive to t
11Connecting Two ATA Disk Drives to the Same CableWhen you connect two ATA disk drives to a cable, one disk drive must be set as the master, the other
12Mounting ATA Disk Drives and Connecting CablesTo complete the hardware installation:1 Mount each ATA disk drive in an available drive bay inside you
13Installing the Device DriverBefore you can begin using your ASH-1233 adapter and ATA drives, you must install the device driver. Follow the instruct
14Windows 2000When you power on your computer, Windows automatically detects the new adapter and opens the New Hardware Installation Wizard. To comple
15Windows 98SENote: You may need your Windows 98SE CD during installation.When you power on your computer, Windows automatically detects the new adapt
RAdaptec, Inc.691 South Milpitas BoulevardMilpitas, CA 95035 USA©2004 Adaptec, Inc.All rights reserved. Adaptec and the Adaptec logo are trademarks of
1In this Booklet...This Installation Guide explains how to install the Adaptec ASH-1233 adapter, connect ATA hard disk drives to it, and install the d
2System RequirementsThe minimum system requirements for the ASH-1233 adapter are: Pentium II-266 MHz Processor or higher Microsoft® Windows® 98SE, W
3This is Your Adaptec ASH-1233 AdapterInstallation ChecklistTo successfully install your Adaptec ASH-1233 adapter and ATA disk drives, perform these t
4Installing Your Adaptec ASH-1233 AdapterYou can install your Adaptec ASH-1233 adapter into a 32-bit or 64-bit PCI expansion slot.Note: If you are ins
53 Locate an unused expansion slot and remove the slot cover. Save the slot cover screw for use in Step 5.Expansion slot coverSlot cover screw64-bit P
64 Insert the ASH-1233 adapter in the PCI expansion slot. Press down firmly until the adapter clicks into place. When installed properly, the adapter
7Preparing Your ATA Disk DrivesBecause setup can vary from device to device or computer to computer, always refer to your ATA disk drive and computer
8Connecting Your ATA Disk DrivesThe ASH-1233 adapter supports up to four ATA disk drives in a master/slave configuration. (See Setting Jumpers on ATA
Commentaires sur ces manuels