Adaptec APA-1460A Guide de l'utilisateur télécharger pdf (Page 14)

SlimSCSI 1460 Adapter User’s Guide

Completing the SlimSCSI Installation in

Windows NT

The SlimSCSI adapter is supported under Windows NT version 3.51

and higher.

Note:

Windows NT 3.51 does not support hot plugging or hot

swapping. This means that the SlimSCSI adapter and the

devices connected to it must be plugged in and powered

before you start Windows NT and that you cannot remove

the adapter (or other PC Cards) while Windows NT is

running.

If Windows NT Is Not Installed on Your PC

If Windows NT is not already installed on your PC, install it now

and then continue with the instructions in the next section, If

Windows NT Is Installed on Your PC.

Follow these steps if you need to install Windows NT from a

CD-ROM drive connected to your SlimSCSI adapter:

Insert the SlimSCSI adapter in a PC Card slot, connect the

CD-ROM drive to it, and turn the drive

Be sure the CD-ROM drive is terminated, if it is the last (or only)

SCSI device on the bus. Also, be sure that you have installed

your PC’s version of DOS Card and Socket Services.

Boot the PC to DOS and insert the EZ-SCSI diskette #2 in the

PC’s floppy drive.

At the DOS prompt, change to the drive letter of the floppy

drive (usually a:), type dosinst, and press Enter.

Follow the instructions that appear on the screen. EZ-SCSI will

install the drivers required by the CD-ROM drive.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 37 38

Pas de commentaire

Adaptec APA-1460A Guide de l'utilisateur Page 14